Author: admin

  • INSTRUCTION MANUAL EBARA Self Priming Pumps SQPB

    —

    by

    admin
    in

    INSTALLATION Location(1) This pump should be installed indoors. If it is to be used outdoors, some type of roof or covering will be required to protect the pump from the weather.(2) Install in a well-ventilated area with low humidity. Ambient temperature should be 40o C or less.(3) Install where inspection and maintenance procedures can be…

  • Ebara Europe motor INSTRUCTION MANUAL REGARDING USE AND MAINTENANCE

    —

    by

    admin
    in

    NEVER ALLOW THE MOTOR-DRIVEN PUMP TO OPERATE WITHOUTWATER. DOING SO CAN SERIOUSLY DAMAGE THE INTERNAL COMPONENTS. GENERAL WARNINGSa) Our surface pumps are designed to operate at a temperature no higher than40°C and a level no higher than 1000 metres;b) our motor-driven pumps cannot be used in swimming pools or similar plants; c) prolonged motor pump…

  • Aqua System Pressure Tank / Expansion tank

    —

    by

    admin
    in

    INSTALLATION AND OPERATING INSTRUCTIONS Before turning on the vessel supply, check that it is correctly installed, fill it switching on the pump until the pressure switch turns it off automatically. Turn on and off repeatedly the farest tap in order to exhaust the air bubbles inside the pipes. After this turn on one or more…

  • Expansion tank

    —

    by

    admin
    in

    SPECIFICATION In hot-water heating systems, when the water is being heated from 10 °C to 90 °C its volume expands by %3.55 of its initial volume. In order to absorb this expansion caused by the heat we use expansion tanks. Along with the safety of the system expansion tanks also fulfill the task to prevent…

  • Pressure tank

    —

    by

    admin
    in

    Principle use pressure tank Reducing the running time of pumps in booster systems, preventing the water hammer in installations and storing ready-for-use pressurized water are among the main tasks of a booster pressure tank. The volume and the pressure class of the booster pressure tank depends on the specifications and application requirements of the booster…

  • Pressure tank Instruction

    —

    by

    admin
    in

    a pressure balance tank for sanitary installations to prevent the over-operation of the water pump Reducing the running time of pumps in booster systems, preventing the water hammer in installations and storing ready-for-use pressurized water are among the main tasks of a booster pressure tank. MAINTENANCE 1. Maintenance should be realized by qualified personnel and…

  • 03 PUMP LOAD CHART

    —

    by

    admin
    in

    This chart show how 3 pump run follow time and pressure

  • Regular Electric Motor Inspections

    —

    by

    admin
    in

    Frequency Inspection  Items Daily check (1) Inspect exterior Daily check (2) Check for vibration or unusual sounds. Daily check (3) Check bearing temperature. Daily check (4) Check frame temperature. Daily check (5) Remove any dirt or debris from slip rings and brush holder area. Annually check (1) Check bearing grease and lubricating oil levels and…

  • INSTRUCTION FSA PUMP

    —

    by

    admin
    in

    A -Installation A -Installation  Before insulation resistance measurement, always disconnect the power first. All electric work should be performed by a qualified electrician and all national and local electrical codes must be observed.  1.    Location (1)  This pump should be installed indoors. If it is to be used outdoors, some type of roof or covering…

  • Regular Pump Inspections

    —

    by

    admin
    in

    (1) Inspect pump appearance. (2) Check for vibration or unusual sounds. (3) Check bearing temperature. Confirm that room temperature  is 40°C or less. (4) Check lubricating  oil pressure – for oil bath bearing (5) Check for excessive  generation  of heat in gland. (6) Check for water leakage from gland packing/ mechanical seal (7) Check pressure …